Product parts details
First, remove the headlight from the car, then put the headlight into the oven to heat it and separate the lampshade and the back shell.
Remove the original headlight inner lens assembly and do not retain it (the parts in the figure below are not retained). Use the adjustment buckle back to the original car, and be careful to protect it when disassembling.
Install the lens group on the kit bracket. The kit design uses a set of 3-inch square lenses + a set of 1.5/1.7 matrix module lenses (note that the matrix module lenses must have waist mounting holes)
After the lens is assembled, use the 3-inch square lens as a reference to adjust the matrix lens light pattern to be consistent with the 3-inch lens. The kit is designed with a convenient adjustment screw, and the light pattern can be quickly adjusted using an M4 sleeve.
After the lens is assembled, install the kit’s decorative frame onto the lens bracket and secure it with four screws. Be careful to protect the decorative frame during installation.
Due to the limited space inside the headlight, it is recommended to select the appropriate lens according to the size marked in the figure
Install the assembled lens assembly into the back shell
The actual effect after installation is shown in the figure below
Wiring Instructions:
The decoder has three wires: black to the negative terminal, white to the positive terminal, and green to the low-beam signal terminal.
Cut the low-beam signal wire from the headlight connector and connect the input to the decoder (the signal wire does not pass through the original vehicle driver).
H4 wire group takes signal: negative pole takes No. 1, low beam takes No. 5, high beam takes No. 6
After wiring is complete, please be sure to test all functions in the vehicle (including dimming) before turning off the lights.
The following image shows the effect after turning off the lights.
The actual appearance after the lights are turned off
The loading effect diagram is as follows
